- ✓Crisp small features; low warping
- ✓Basic: tougher and stiffer
- ✓Matte: subdued finish hides layer lines
- ✓Pure: Made for food contact and toys · lower emissions
Included all-rounder: broad starter-material compatibility, reliable cooling release and a durable surface. The drawback is a textured underside.
Provides smooth undersides, flat mating faces and fine first-layer lettering. PETG/TPU/ABS often need glue as a release layer; coating requires careful print removal.
PLA/PETG-specific. Useful when narrow contact areas lift on regular PEI; strong grip at lower bed temperature. Softer coating, harder release and narrower compatibility. No glue normally needed.
For repeated high-bed-temperature printing of PC, nylon and reinforced engineering filaments. Tolerates demanding heat cycles, but needs glue and more cleanup.
Not a print surface. Used for XY motion calibration and tight-fit dimensional work. Not required for everyday decorative prints.